Calculated-industries 4095-C User Guide Manual de usuario descargar pdf (Pagina 11)

12 — PiPe Trades Pro™

Pipetting Project Keys

Travel

Slope

Offset

Angleº

 Enters or calculates a linear Slope, Slope Angle,

or Percent Grade. The linear slope is the amount

of "Offset" over 12 inches of "Run." Values may be

entered as:

● a Dimension:   A

● an Angle or Degrees:   A

● a Percentage (percent grade): 7    A

Once an angle or slope has been entered, consec-

utive presses of A will convert to the remaining

formats listed above.

 Take-Out (T.O./Arc) – Used to enter or solve t-

ting Take-Outs when calculating pipe cut lengths.

Calculates inner, center, and outer arc lengths for

marking eld cut ttings.

 Calculates or enters the Offset (Rise).

 Welder's Gap – Denes the Welder's Gap sub-

tracted from the end to end pipe length calculation.

Default value is 1/8", 0 is a valid value.

 Enters or calculates the Run.

 Enters or calculates the Travel (Diagonal).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 64 65

Sin comentarios

Calculated-industries 4095-C User Guide Manual de usuario Pagina 11