Calculated-industries 4095-B User Guide Manual de usuario descargar pdf (Pagina 36)

36 — PIPE TRADES PRO™

4. Enter the advance:

    (Advance) RUN 32 INCH

5. Enter the Roll and calculate the pipe length and unknown

bend angle:

      (Roll) LNTH 42-1/16 INCH

  CUT 35-1/4 INCH

  TO 3-5/16 INCH

  GAP 0-3/32 INCH

  FIT° 40.46°

  IARC 4-1/32 INCH

  CARC 6-11/32 INCH

  OARC 8-11/16 INCH

*Note: Setting welder's gap to 3/32 inch will temporarily set the

outputs to 1/32 fractional resolution. To keep outputs in their

current fractional resolution (default is 1/16) press  once

after entering the welder's gap. For example, if you keep the

fractional resolution at 1/16, the outputs above for IARC would

be 4 inches, and CARC would be 6-3/8 inches.

The cut length for the pipe is 35 and 1/4 inches and bend angle

is 40.46°. Included in the outputs are the arc lengths to be used

to cut your butt weld elbow to the calculated bend angle. These

are inner arc length of 4 and 1/32 inches, center arc length of 6

and 11/32 inches, and outer arc length of 8 and 11/16 inches.

KEYSTROKE DISPLAY

(cont'd)

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 67 68

Sin comentarios

Calculated-industries 4095-B User Guide Manual de usuario Pagina 36