Calculated-industries 4095-B User Guide Manual de usuario descargar pdf (Pagina 35)

USER’S GUIDE — 35

Rolling Offset – Cut Length

Find the end-to-end pipe length for a rolling pipe offset with a

13” Roll, a 24” Offset, and an advance of 32”. The bend angle

is unknown. This example assumes 6” Steel, factory made long

radius butt weld elbows are used with a Welder’s Gap of 3/32”.

Note: the default Welder’s Gap is 1/8”.

Note: All Take-Out calculations are based on Carbon Steel

O.D. See the Cut Length – Known Take-Out Value example

to solve Cut Lengths for known Take-Out values.

ADVANCE

LENGTH

OFFSET

ROLL

BEND

KEYSTROKE DISPLAY

  ALL CLEArEd

1. Enter Pipe Size:

   STD SIZE 6 INCH

2. Change the default Welder’s Gap from 1/8” to 3/32”:

     * GAP 0-3/32 INCH

3. Enter Offset:

    OFST 24 INCH

(cont'd)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 67 68

Sin comentarios

Calculated-industries 4095-B User Guide Manual de usuario Pagina 35