Calculated-industries 6260 User Guide Manual de usuario descargar pdf (Pagina 43)

DIGITIZER MODE

The Ultra Scale Master Pro can be used as a Digitizer to send measurement data (X,Y coordinates) and key press data to digitizing

software on a host personal computer (PC). See PC Interface section for system requirements and USB connection information.

Press the [DIGITIZER] key to enter Digitizer Mode. Display will show “digi On.” It will remain in Digitizer Mode until the

[DIGITIZER] key is pressed again, or when a manual reset is performed (see Reset section).

WHILE IN DIGITIZER MODE:

The following keys send measurement data (X,Y coordinates) and key press data:

[MEASURE]

[END]

[CLOSE –]

[CLOSE +]

The following keys send only the key press data:

[UNDO] D-Pad Up [

] [PC SEND] [MODE] [HEIGHT]

D-Pad Down [

] [ARC/CIRC] [SCALE] [PREFS]

[M+] D-Pad Right [

] [MR] [UNITS]

D-Pad Left [

]

The following keys send no data:

[ON/CLEAR]

[SET]

[DIGITIZER]

USER’S GUIDE — 41

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 51 52

Sin comentarios

Calculated-industries 6260 User Guide Manual de usuario Pagina 43