Calculated-industries 6020 v3.1 Manual de usuario descargar pdf (Pagina 5)

3 – User’s Guide

a height has been stored. Please see page 12 for

calculating an Area and Volume.

[RESET]

Used to clear the display. When pressed together

with another key, clears the value of that key.

Imperial/Metric Modes

e Scale Master Classic is set up to use Imperial

(Standard) scales by default. e Scale Master

Classic can be set up to use Metric mode by

performing the following steps:

1) All Clear by pressing [RESET] and

[SUBTRACT/COUNT] simultaneously.

"ALL

CLEARED

" should display for 1 second.

2) Press and hold [RESET], then press [MODE]

twice.

3) Release the [RESET] key.

While in Metric mode, MET will remain lit in

the display.

Repeat the steps above to switch back to

Imperial mode.

Us i n G T h e sC a l e Ma s T e r ClassiC

Adjusting the Wheel

e Celcon® polymer

wheel can be adjusted for

each user’s preference. To

adjust the wheel, take a

small, ﬂat-head jeweler’s screwdriver and slightly

rotate the screw located near the wheel tip.

Rotating the screw about 1/4 to 1/3 turn should

Rotate to Adjust Wheel

(Cont’d)

1 2 3 4 5 6 7 8 9 10 ... 39 40

Sin comentarios

Calculated-industries 6020 v3.1 Manual de usuario Pagina 5