Calculated-industries 4095-A User Guide Manual de usuario descargar pdf (Pagina 42)

40 — Pi P e Tr a d e s Pro™

E r r o r s — When an incorrect entry is made, or the answer

is beyond the range of the calculator, it will display the word

“ERROR.” To clear an error condition you must hit the 

button once. At this point you must determine what caused the

error and re-key the problem.

ERROR CODES

DISPLAY ERROR TYPE

OFLO Overow (too large)

MATH Error Divide by 0

DIM Error Dimension error

ENT Error Invalid entry error

A u t o - R a n g e — If an “overow” is created because of an

input and calculation with small units that are out of the

standard seven-digit range of the display, the answer will be

automatically expressed in the next larger units (instead of

showing “ERROR”) — e.g., 20,000,000 mm is shown as 20,000

m. Also applies to inches and feet.

AUTO SHUT-OFF

Your calculator is designed to shut itself off after about 8-12

minutes of non-use.

BATTERIES

The Pipe Trades Pro uses two LR-44 batteries.

Replacing Batteries

Should your calculator display become very dim or erratic,

replace the batteries.

Note: Please use caution when disposing of your old battery,

as it contains hazardous chemicals.

Replacement batteries are available at most discount or

electronics stores. You may also call Calculated Industries at

1-775-885-4900.

UG4095E-A.indd 40 5/5/2009 9:09:35 AM

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48 49 50

Sin comentarios

Calculated-industries 4095-A User Guide Manual de usuario Pagina 42